Configure IPv6 on Nginx instances in Lightsail
All instances in Amazon Lightsail have a public and a private IPv4 address assigned to them by default. You can optionally enable IPv6 for your instances to have a public IPv6 address assigned to them. For more information, see Amazon Lightsail IP addresses and Enable or disable IPv6.
After you enable IPv6 for an instance that uses the Nginx blueprint, you must perform an additional set of steps to make the instance aware of its IPv6 address. In this guide, we show you the additional steps that you must perform for Nginx instances.
Prerequisites
Complete the following prerequisites if you haven't already:
-
Create an Nginx instance in Lightsail. For more information, see Create an instance.
-
Enable IPv6 for your Nginx instance. For more information, see Enable or disable IPv6.
Note
New Nginx instances created on or after January 12, 2021, have IPv6 enabled by default when they are created in the Lightsail console. You must complete the following steps in this guide to configure IPv6 on your instance even if IPv6 was enabled by default when you created your instance.
Configure IPv6 on a Nginx instance
Complete the following procedure to configure IPv6 on a Nginx instance in Lightsail.
-
Sign in to the Lightsail console
. -
Important
The Lightsail browser-based SSH/RDP clients only accept IPv4 traffic. Use a third-party client to SSH or RDP into your instance over IPv6. For more information, see Connect to your instances.
In the Instances section of the Lightsail home page, locate the Ubuntu 16 instance that you wish to configure, and choose the browser-based SSH client icon to connect to it using SSH.
-
After you're connected to your instance, enter the following command to determine if your instance is listening to IPv6 requests over port 80. Be sure to replace
<IPv6Address>with the IPv6 address assigned to your instance.curl -g -6 'http://[<IPv6Address>]'Example:
curl -g -6 'http://[2001:0db8:85a3:0000:0000:8a2e:0370:7334]'You will see a response similar to one of the following examples:
-
If your instance is not listening to IPv6 requests over port 80, then you will see a response with a Failed to connect error message. You should continue to complete steps 4 through 9 of this procedure.
-
If your instance is listening to IPv6 requests over port 80, then you will see a response with the HTML code of the home page of your instance as shown in the following example. You should stop here; you do not need to complete steps 4 through 9 of this procedure because your instance is already configure to for IPv6.
-
-
Enter the following command to open the nginx.conf configuration file using Vim.
sudo vim /opt/bitnami/nginx/conf/nginx.conf -
Press
Ito enter insert mode in Vim. -
Add the following text below the
listen 80;text that is already in the file. You might need to scroll down in Vim to see the section where you need to add the text.listen [::]:80;The file will look like the following when done:
-
Press the Esc key to exit insert mode in Vim, then type
:wq!and press Enter to save your edits (write) and quit Vim. -
Enter the following command to restart the services of your instance.
sudo /opt/bitnami/ctlscript.sh restart -
Enter the following command to determine if your instance is listening to IPv6 requests over port 80. Be sure to replace
<IPv6Address>with the IPv6 address assigned to your instance.curl -g -6 'http://[<IPv6Address>]'Example:
curl -g -6 'http://[2001:0db8:85a3:0000:0000:8a2e:0370:7334]'You will see a response similar to the following example. If your instance is listening to IPv6 requests over port 80, then you will see a response with the HTML code of the home page of your instance.
